The VBM () is designed to measure strip thickness on high quality strip in fast running cold rolling mills. The gauge measures the passing material continuously in its measurement mouth which has a depth of ()mm (appr. 3,9" / ").The difference between VBM and VBM.
the lower one, but lifts off from the lower ram, the gauge would indi-cate a wrong strip thickness size. Insertion of the adjustment plate: Set the C-frame M to the 90°-posi-tion by means of the adjustment pin in the adjustment bore J. Put the alignment block P (shown in the sketch with a similar gauge).
The coils are formed by running a continuous sheet of metal through a roll slitter. In most of the world, sheet metal thickness is consistently specified in millimeters. In the US, the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its gauge. The larger the gauge number, the thinner the metal.
GAUGE TO THICKNESS CHART Gauge Stainless Galvanized Sheet Steel Aluminum Fraction inches (mm) inches (mm) inches (mm) inches (mm) 30 () () () ().